Chemilizer HN55 Injector is an easy way to administer water soluble antibiotics or liquid chemicals to several animals at once. The Chemilizer HN55 Injector inserts into the animal's water supply, consistent and precise amounts of medication or chemicals regardless of fluctuations in water pressure or flow. Powered by the existing water supply and designed to protect the motor from corrosive chemicals so it lasts longer. Does not require electricity or water filtration. Mounting hardware is included.
Caution: To reduce the risk of a chemical overdose, follow proper installation methods and instructions. The point of chemical injection should be beyond all pumps, filters and heaters.
Unit installations must always adhere to your local plumbing codes and requirements. Check local plumbing codes for guidelines.
Can run off of water flows as low as one gallon per hour, and will work with gravity via a water drop of as little as 5 feet.
Fixed injection rate of 1:128
Max. temperature: 100°
Size: 11"H x 8.5"W
Weight: 4.54 lbs.
Pipe Size: ¾" national hose thread.
Includes quick start guide, instruction manual and mounting hardware.
Water is always a factor with the life of any injector. If you know you have problem water, an in-line filter before the injector is suggested.
Do not let unit freeze. Never leave the injector or water lines full of water during freezing temperatures. Visually inspect the injector and water system for leakage.
Never install an injector directly over the solution tank. The suction hose from the tank to the injector should fall below the top of the tank, then rise back up to the injector.
Periodically clean or replace the chemical hose and connectors. Chemical buildup will cause the unit not to pump.
Clean pump after use by running clean water through the pump for 5 minutes or by removing the pump and hand cleaning the individual parts.